Disconnect the Starter Relay connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.

Connect the GDS and go to “Current Data”.

Monitor Starter Relay values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).

Any change in the values indicates a poor connection. Was a connector problem found?

	▶ Repair the connector. Go to "Verification of Vehicle Repair" procedure.
	▶ Go to next step as below

IG "OFF".

Disconnect Starter Relay.

IG "ON"

Measure the voltage between control terminal of Starter Relay harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to " Output Power Circuit Inspection" procedure.
	▶ Repair Short to battery in control circuit, and go to "Verification of vehicle Repair" procedure.