System Inspection
■ Check Generator circuit
1.

Engine starts.

2.

Maintain ENG RPM 2,500RPM over 2 minutes.

3.

Measure voltage between the battery terminal(+) and the battery terminal(-).

Specification : Approx. 12.5 ~ 14.7V

4.

Is the measured voltage within specification?

▶ Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. So, check poor connections and the related circuit between ECM and component thoroughly. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Check that the tension of drive belt, ENG RPM, fuse, terminal of battery, all terminals of generator are in good condition and Check for damaged harness and poor connection between generator and battery. If OK repair or replace generator and then go to "Verification of vehicle Repair" procedure.

Яндекс.Метрика