3.
Remove the intercooler outlet hose (A).
Tightening torque:
4.9 ~ 6.8 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)
Disconnect the battery negative (-) terminal.
Remove the air duct and air cleaner assembly.
(Refer to Intake and Exhaust System - "Air Cleaner")
Remove the intercooler outlet hose (A).
Tightening torque:
4.9 ~ 6.8 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)
Remove the intercooler inlet hose & pipe (A).
Tightening torque
Bolt :
19.6 ~ 26.4 N.m (2.0 ~ 2.7 kgf.m, 14.4 ~ 19.5 lb-ft)
Clamp :
4.9 ~ 6.8 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)
Disconnect the boost pressure sensor connector, RCV solenoid valve connector (A) and cooling fan controller connector (B).
Remove the front bumper.
(Refer to Body (Interior And Exterior) - "Front Bumper")
Remove the intake shield (A).
Remove the intercooler upper mounting bolts (A) and then remove the intercooler upper mounting bracket.
Remove the air guide (A).
Remove the intercooler.
Install in the reverse order of removal.
Match the marking part of hose and marking part of throttle body, compressor.
Match the pipe stopper and hose marking.
When the band part is placed on the position mark of hose, install not to exceed the mark.
Tighten until the torque control cap is released. If there is no torque control cap, tighten as specified torque.
