3.
Disconnect the solenoid valve connector (A).
Turn ignition switch OFF.
Remove the air duct cleaner.
(Refer to Engine Mechanical System - "Air cleaner")
Disconnect the solenoid valve connector (A).
Measure resistance between sensor signal terminal and sensor ground terminal.
Check that the resistance is within the specification.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
Disconnect the input & output speed sensor connector (A).
Loosen the main connctor bolt (B).
Tightening torque:
(B) 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Dissconnect the solenoid valve connector (A).
Remove the solenoid valve connector after removing a clip (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Installation is the reverse of removal.
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
Use new valve body gasket (A).
