3.
Monitor the "Steering Angle Sensor Calibrated" parameters on the GDS.
Specification : OK
Fig.1) SAS Calibrate normal data
Connect GDS to Data Link Connector(DLC)
Ignition "ON".
Monitor the "Steering Angle Sensor Calibrated" parameters on the GDS.
Specification : OK
Fig.1) SAS Calibrate normal data
Is parameter displayed within specifications?
 | ▶ Fault is caused by having been repaired and HECU memory was not cleared. Clear the DTC and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Component Inspection" procedure. |
