Adjustment
Parking Brake Lever Stroke Adjustment
1.

Raise the vehicle, and make sure it is securely supported.

2.

Remove the floor console rear cover(A).

3.

Adjust the parking brake lever stroke by turning adjusting nut (A).

Parking brake lever stroke :

6~8 cliks (Pull the lever with 196N (20 kgf, 44 lb))

note

After repairing the parking brake shoe, adjust the brake shoe clearance, and then adjust the parking brake lever stroke. (Refer to "Parking brake shoe installation")

4.

Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.

5.

Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.

6.

Install the floor console rear cover(A).

note

Bring the brake pads in their operating position by pressing the brake pedal down (half of normal pedal travel) several times until there is resistance.

In order to bed the brake pads to the brake disc and ensure performance and endurance, the vehicle user must be instructed to avoid heavy braking or sustained periods with the brakes applied, for the first 200km (124mile) after installing new pads.

Parking Brake Adjustment
note

Re-setting of the parking brake is necessary after overhauling the caliper body, or if the brake calipers, housing, parking brake cable or brake discs have been changed.

1.

Remove the floor console to reach the adjusting nut.

2.

Loosen the parking brake cable until both operating levers rest in fully off position.

3.

Bring the brake pads in their operating position by pressing the brake pedal down several times until there is resistance.

4.

Tension the parking brake cable by tightening the adjusting nut, until the operating levers on both calipers lift from the stop, up to a distance of 0.5-1.0 mm(0.019~0.024in) between operating lever and bracket.

5.

Refit the floor console.

6.

Parking brake lever in the car must be in fully loosened position.

7.

If the handbrake cables where changed, actuate the parking brake a few times with maximum force to stretch the parking brake cables, and then control adjusting as above.

8.

Check the wheels of their free operation.

9.

Test drive.

Яндекс.Метрика