Ignition "OFF".
Disconnect duct sensor.
Using the multi-tester, Measure resistance between terminal "1" and "2" of duct sensor.
Discharge temperature [°C(°F)] | Resistance [KΩ] |
-10(14) | 16.54 |
-5(23) | 12.66 |
0(32) | 9.77 |
5(41) | 7.59 |
10(50) | 5.96 |
15(59) | 4.68 |
20(68) | 3.72 |
25(77) | 2.993 |
30(86) | 2.41 |
35(95) | 1.95 |
40(104) | 1.59 |
45(113) | 1.30 |
50(122) | 1.07 |
If the measured resistance is not specification, substitute with a known-good duct temperature sensor and check for proper operation.
If the problem is corrected, replace the duct temperature sensor.
Disconnect the negative (-) battery terminal.
Remove the left side cover (A).
Remove the crashpad lower cover (A).
Remove the crash pad side switch assembly (A).
Remove the crashpad lower panel (A).
Remove the left shower duct (A).
Remove the brake pedal.
(Refer to BR group - "Brake Pedal")
Remove the discharge temperature sensor (A), by pulling it after rotating 90° in a counter clock wise direction.
Installation is the reverse order of removal.
