2.
After loosening the seat assembly mounting bolts, remove the seat assembly (A).
Tightening torque :
34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~39.8 lb-ft)
Remove the seat assembly mounting cover.
After loosening the seat assembly mounting bolts, remove the seat assembly (A).
Tightening torque :
34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~39.8 lb-ft)
Disconnect the airbag connector (A), seat heater connector (B).
Installation is the reverse of removal.
Seat Mounting Bolt Installation Procedure
Set the into the most rearward position. Check then each slide is locked, and then Tighten the front mounting bolt temporarily.
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
Set the seat into the most rearward position. Check the front mounting bolt completely.
Check that the seat operates to and fro smoothy and the locking portion locks properly.
Remove the height cap (A).
After loosening the mounting screws, then remove the height knob (B).
Using a screwdriver, remove the recliner dial knob (C).
After loosening the mounting screws, then remove the shield cover (A).
Installation is the reverse of removal.
Remove front seat assembly.
Push the lock pin (B), remove the headrest (A).
Disconnect the protector (A).
Disconnect the connector (A) mounting clip.
Zip off the armrest cover (A), and then full it up.
After loosening the mounting bolt, then remove the armrest (A).
Remove the hogring clips (A).
Zip off the seat back cover (A), and then full it up.
Pull out the headrest guides (A) while pinching the end of the guides, and remove them.
Remove the seat back from the frame.
After removing the hogring clips (B) on the front of seat back and remove the seat back cover (A).
Installation is the reverse of removal.
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hogring clips (A).
Replace the hogring clips with new ones using special tool (C) (09880-4F000).
Remove front seat assembly.
Remove the recliner cover.
After disconnect the protector (A), then remove the seat cushion (B).
Disconnect the connector (A) mounting clip.
After removing the hogring clip (A) on the front ofseat cushion and remove the seat cushion cover (B).
Installation is the reverse of removal.
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hogring clips (A).
Replace the hogring clips with new ones using special tool (C) (09880-4F000).
Remove the following items.
Front seat
Seat back cover
Seat cushion cover
Headrest guide
After loosening the mounting screws, then remove the inside shield cover (A).
After loosening the mounting bolts, then disconnect the seat back frame (A) and seat cushion frame (B).
Tightening torque :
44.1 ~ 58.8 N.m (4.5 ~ 6.0 kgf.m, 32.5 ~ 43.4 lb-ft)
Installation is the reverse of removal.
