Use fender covers to avoid damaging painted surfaces.

To avoid damage, unplug the wiring connectors carefully while holding the connector portion.

Mark all wiring and hoses to avoid misconnection.

Remove the engine cover and air cleaner assembly. (Refer to "Intake and exhaust system" in EM group)

Remove the ECU and battery. (Refer to "Charging System" in EE group)

Remove the battery tray (A).

Disconnect the vehicle speed sensor connector (A) and the back lamp switch connector (B).

Disconnect the neutral switch connector.

Remove the ground wire by removing a bolt.

Remove the snap pins (A) and clips (B).

Remove the control cable bracket by removing bolts(3ea).

Remove the CKP sensor by removing a bolt.

After removing the clip (A) and take off the clutch tube, remove the bracket mounting bolt (B).

Remove the cowl top cover or wiper motor. (Refer to "Windshield Wiper/Washer" in BE group.)

Remove the cowl complete assembly panel (A).

Remove the head lamp.(Refer to "Lighting System" in BE group.)

Using the engine support fixture [Support (A)-SST No.: 09200-1P000, Beam (B)-SST No.: 09200-38001], hold the engine and transaxle assembly safely.

Remove the transaxle upper mounting bolts (A-2ea) and the starter motor mounting bolts (B-2ea).

Remove the transaxle support bracket bolts (A-3ea).

Lifting up the vehicle.

Remove the under cover (A).

Drain the transalxe fluid by removing the drain plug (A).

Disconnect the drive shafts from the transaxle. (Refer to "Front Driveshaft" in DS group)

Remove the dust cover by removing the bolts(2ea).

Loosen the turbo charger hose by loosening a clamp and removing the bolts(2ea).

Remove the roll stopper bracket by removing bolts(A-1ea,B-2ea).

Remove the clutch release cylinder assembly(A) by removing bolts(B-2ea).

Remove the bolt left in the engine side.

Supporting the transaxle with a jack, remove the transaxle lower mounting bolts(A-3ea, B-1ea).

Lowering the jack slowly, remove the transaxle.