1.
Remove the connector after(A) removing the rear wheel speed sensor clip.
Remove the connector after(A) removing the rear wheel speed sensor clip.
Remove the rear wheel speed sensor. (Refer to Driveshaft and axle group - Rear axle assembly)
Installation is the reverse of removal.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
In order to protect the wheel speed sensor, when measuring output voltage, a 100Ω resistor must be used as shown.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.
V_low : 0.59 V ~ 0.84 V
V_high : 1.18 V ~ 1.68 V
Frequency range : 1~2,500 Hz
