3.
Disconnect the connectors from the actuator.
[LHD]
[RHD]
Remove the front door trim.
(Refer to the BD group - "Front door")
Remove the front door module.
(Refer to the BD group - "Front door")
Disconnect the connectors from the actuator.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
※ Front left (Front right)
※ Front right
※ Front left (Front right)
Dead lock mode (sequence) :
Central door lock → Dead lock
Dead unlock mode (sequence) :
Dead unlock → Central door unlock
Remove the rear door trim.
(Refer to the BD group - "Rear door")
Remove the rear door module.
(Refer to the BD group - "Rear door")
Disconnect the connectors from the actuator.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
※ Rear left (Rear right)
※ Rear left (Rear right)
Remove the tailgate trim.
(Refer to the BD group - "Tailgate")
Disconnect the 4P connector from the actuator.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Remove the front door trim.
(Refer to the BD group - "Front door")
Remove the front door module.
(Refer to the BD group - "Front door")
Disconnect the connectors from the actuator.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.
※ Front left (Front right)
※ Front right
※ Front left (Front right)
Remove the rear door trim.
(Refer to the BD group - "Rear door")
Remove the rear door module.
(Refer to the BD group - "Rear door")
Disconnect the connectors from the actuator.
Check for continuity between the terminals in each switch position according to the table.
※ Rear left (Rear right)
※ Rear left (Rear right)
Remove the tailgate trim.
(Refer to the BD group - "Tailgate")
Disconnect the 4P connector from the actuator.
Check for continuity between the terminals in each switch position according to the table.
Remove the tailgate trim.
(Refer to the BD group - "Tailgate")
Remove the tailgate garnish after disconnecting the connector.
(Refer to the BD group - "Tailgate")
Remove the tailgate outside handle after removing the screws (2EA).
Remove the door switch and check for continuity between the terminals.
Disconnect the connector (A) and bolt from the hood switch.
Check for continuity between the terminals and ground according to the table.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
Disconnect the 6P connector from the key warning switch.
Check for continuity between the terminals in each position according to the table.
Remove the burglar horn after removing a bolt and disconnect the 2P connector from the burglar horn (A).
Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.
The burglar horn should make a sound. If the burglar horn fails to make a sound replace it.
