1.
With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.
With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.
Disconnect the negative(-) battery terminal.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
Remove the junction box.
Check for continuity between the terminals.
There should be continuity between the No.2 terminals in the I/P-B and No.13(or No.15) in the I/P-H(or I/P-F) when power and ground are connected to the No.2 or 7 terminals in the I/P-G and No.6 terminals in the I/P-G.
There should be no continuity between the No.2 terminals in the I/P-B and No.13(or No.15) in the I/P-H(or I/P-F) when power is disconnected.
Disconnect the negative (-) battery terminal.
Remove the front bumper.
(Refer to the BD group - "Front bumper")
Remove the front fog lamp (A) by turning in the counter clock-wise direction after disconnecting the connector.
Install the front fog lamp bulb.
Connect the front fog lamp connector.
Install the front bumper.
