3.
Remove the shift cable assembly by pulling out the clamp as shown in the illustration.
Remove the center console (Refer to Console in BD group)
Remove the snap pin (A) and remove the shift cable assembly (B) from the shift lever assembly.
Remove the shift cable assembly by pulling out the clamp as shown in the illustration.
Remove the shift lock cable (A).
Remove the shift lever assembly (A)by removing the bolt.
Tightening torque :
9~14N.m (0.9~1.4kgf.m, 6.0~9.5lb-ft)
Remove the retainer (A) and (B).
Tightening torque :
9~14N.m (0.9~1.4kgf.m, 6.0~9.5lb-ft)
Remove the shift cable assembly from the transaxle.
Tightening torque :
10~14N.m (1.0~1.4kgf.m, 7.2~10.1lb-ft)
Set the room side lever and the manual lever (A) to "N" position.
Push the shift cable (B) lightly to "F" direction shown to eliminate the free play.
Tighten the adjusting nut (C).
Tightening torque :
10~14N.m (1.0~1.4kgf.m, 7.2~10.1lb-ft)
Check that this part operates at each range of the manual lever corresponding to each position of the room lever.
Installation is the reverse of removal.
