Check for abnormal noise or bending during operation.
With the sunroof fully closed, check for water leakage.
The roof molding (A) should be even with the glass (B) weatherstrip, to within the standard value "E" all the way around. If not, make the following adjustment.
Standard value "E" [mm(in.)]
(1) Front edge : 7.0 ± 1.0 mm (0.2756 ± 0.0394 in.)
(2) Rear edge : 5.0 ± 1.5mm (0.1969 ± 0.0591 in.)
(3) Side edge : 6.0 ± 1.0mm (0.2362 ± 0.0394 in.)
If the position is not as specified, lightly loosen the glass adjusting screws (A) to adjust the glass height and tighten it.
Whenever the battery is disconnected, discharged or the related fuse is replaced or reinstalled, the panoramaroof system must be reset according to the procedure below.
Turn the ignition key to the ON position and then close the panoramaroof completely.
Release the panoramaroof control lever.ing the switch)
Press and hold the CLOSE button for more than 10 seconds until the sunroof has moved slightly.
Release the panoramaroof control lever.
Press and hold the CLOSE button once again until the sunroof do as follows.
Tilt → Slide Open → Slide Close
Then, release the lever.
Reset procedure of panorama system is finished.
First operation the vehicle after manufacture it.
Initial value is erased or damaged because of short power electric discharge during operation.
After using the manual handle.
Use the panoramaroof emergency handle to close and open the panoramaroof manually for the following case only.
To close the panoramaroof before driving a vehicle in arainy day or on the highway if the panoramaroof can not be closed due to failure of the panoramaroof motor or controller.
Operating method
Remove the overhead console
Push the emergency handle up into the hexagonal drive of the panoramaroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
Carefully turn the emergency handle clockwise to close the panoramaroof.
After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle.
Do not use power tools to operate the panoramaroof.
Damaged to the components may occur.
