1.
After loosening the mounting screws, then remove the sunvisor (A) and retainer (B).
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Put on gloves to protect your hands.
After loosening the mounting screws, then remove the sunvisor (A) and retainer (B).
Installation is the reverse of removal.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Put on gloves to protect your hands.
Remove the covers (B)
After loosening the mounting bolts, then remove the assist handle (A).
Installation is the reverse of removal.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Put on gloves to protect your hands.
Remove the covers (B).
After loosening the mounting screws, then remove the overhead console assembly (A).
Disconnect the connectors (A).
Installation is the reverse of removal.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Put on gloves to protect your hands.
Using a screwdriver, remove the vanity lamp (A).
Disconnect the connector (A).
Installation is the reverse of removal.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap itwith protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Remove the following items.
Front seat (Refer to the BD group – “Front Seat”)
Rear seat (Refer to the BD group – “Rear Seat”)
Interior trim (Refer to the BD group – “Interior Trim”)
Sunvisor
Assist handle
Overhead console
Remove the center seat belt cover (A).
Replacing the part is strongly recommended.
Remove the crash pad side cover (A).
Disconnect the main connector (A).
Remove the mounting clips.
Disconnect the mounting clips, remove the roof trim (A).
Installation is the reverse of removal.
Replace any damage clips.
