2.
Push the lock pin, disconnect the connector (B).
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not bend or scratch the cover and other parts.
After loosening the mounting screws, then remove the rear combination lamp (A).
Push the lock pin, disconnect the connector (B).
After loosening the rear bumper side’s mounting screw and clips, then disconnect the side’s.
Remove the clips.
Loosen the mounting bolts.
After loosening the mounting screws and clips, then remove the rear bumper (A).
Push the lock pin, disconnect the rear bumper main connector (A).
Installation is the reverse of removal.
Make sure the connector is plugged in properly.
Replace any damage clips.
