2.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
When installing the belt, make sure not to damage the pretensioner.
Remove the following items first.
Rear seat assembly
(Refer to the BD group – “Rear Seat”).
Rear door scuff trim
(Refer to the BD group – “Interior Trim”).
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Detach the mounting clips and then remove the transverse trim (A).
Using a screwdriver, remove the lamp (B).
Disconnect the lamp connect (C).
After loosening the mounting screws, then remove luggage side trim (A).
After loosening the mounting screws, then remove the rear fillar trim (A).
If the clips (B) of rear pillar trim (A) are not installed correctly, the curtain airbag abnormal operation might be occured.
After loosening the mounting bolts, then remove the rear seat belt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Replace ant damaged clips.
Remove the center rear seat belt cover (A).
Replacing the part is strongly recommended.
Remove the roof trim
(Refer to the BD group – “Roof Trim”).
After loosening the mounting bolts, then remove the center rear seat belt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Replace ant damaged clips.
Remove the following items first.
Rear seat assembly
(Refer to the BD group – “Rear Seat”).
After loosening the mounting bolt, then remove the seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Remove the following items first.
Rear seat assembly
(Refer to the BD group – “Rear Seat”).
After loosening the mounting bolt, then remove the seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Remove the following items first.
Rear seat assembly
(Refer to the BD group – “Rear Seat”).
After loosening the mounting bolt, then remove the seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
