2.
Pull out the relay from the engine compartment relay box.
A : Head lamp(Low) relay
B : Head lamp (High) relay
Disconnect the negative(-) battery terminal.
Pull out the relay from the engine compartment relay box.
A : Head lamp(Low) relay
B : Head lamp (High) relay
Check for continuity between terminals. There should be continuity between the No.87 and No.30 terminals when power and ground are connected to the No.86 and No.85 terminals.
There should be no continuity between the No.87 and No.30 terminals when power is disconnected.
Head lamps become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off.
The headlamp bulb should not be removed from the headlamp assembly until just before a new bulb is installed.
Removing bulb for an extended period of time may affect headlamp bulb performance.
Contaminants may enter the headlamp assembly where they can settle on the lens and reflector.
Never turn on the head lamps with the bulb removed from the headlamp assembly.
Disconnect the negative (-) battery terminal.
Remove the front bumper.
(Refer to the BD group - "Front bumper")
Loosen the mounting bolts (2EA) of head lamp. Remove the head lamp assembly (A) after disconnecting the lamp connectors.
Take care not to scratch the head lamp lens or fender.
Take care that retaining clips (A) is not to be damaged.
Remove the bulb caps from the head lamp assembly after turning in the counter clock-wise direction.
A : Head lamp low/high cap
B : Turn signal bulb cap
C : Tail lamp bulb cap
Remove the head lamp bulbs after releasing the lock of the set spring.
A : Head lamp low/high bulb
B : Turn signal bulb
C : Tail lamp bulb
Install the head lamp bulbs.
Install the head lamp bulb caps.
Install the head lamp assembly after connecting the lamp connector.
The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions.
If there are any regulations pertinent to the aiming of head lamps in the area where the vehicle is to be used, adjust so as to meet those requirements.
Alternately turn the adjusting gear to adjust the head lamp aiming. If beam-setting equipment is not available, proceed as follows :
Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools.
The vehicle should be placed on a flat floor.
Draw vertical lines (Vertical lines passing through respective head lamp centers) and a horizontal line (Horizontal line passing through center of head lamps) on the screen.
With the head lamp and battery in normal condition, aim the head lamps so the brightest portion falls on the vertical lines.
Make vertical (A) and horizontal (B) adjustments to the lower beam using the adjusting wheel.
The front fog lamps should be aimed as the same manner of the head lamps aiming.
With the front fog lamps and battery normal condition, aim the front fog lamps by turning the adjusting gear (A).
When aiming the front fog lamp, the fog lamp can be adjusted in front of vehicle without removing the front bumper.
The adjusting gear is located inside the radiator grill.
Turn the low beam on with driver seated in the vehicle.
The cut-off line should be projected in the allowable range shown in the picture.
In case of equipping with the manual leveling device, set the leveling device switch on the "O" position.
In case of equipping with the auto leveling device, set the initialization by using the diagnostic tool before aiming.
Turn the front fog lamp on with driver seated in the vehicle.
The cut-off line should be projected in the allowable range shown in the picture.
