4.
Disconnect the curtain airbag harness connector.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
Remove the Interior trim. (Refer to the Body group - Interior trim)
Remove the headlining (Refer to the Body group - Roof trim)
Disconnect the curtain airbag harness connector.
Remove the curtain airbag mounting bolts.
After removing the mounting T-clip remove the curtain airbag.
Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least three minutes.
Insert the curtain airbag mounting T-clip.
Tighten the Curtain Airbag (CAB) mounting bolts.
Tightening torque
: 7.8 ~ 11.8 Nm (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb.ft)
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
Connect the CAB connector.
Install the headlining. (Refer to the Body group - Roof trim)
Install the Interior trim. (Refer to the Body group - Interior trim)
Reconnect the battery negative cable.
After installing the Curtain Airbag (CAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
