2.
Disconnect the connector (A).
Prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
Put on gloves to protect your hands.
Take care not to scratch the body surface.
Remove the tail gate trim.
(Refer to the BD group - "Tail Gate")
Disconnect the connector (A).
After loosening the mounting nuts, then remove the tail gate garnish (A).
Installation is the reverse of removal.
Prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
Put on gloves to protect your hands.
Take care not to scratch the body surface.
Using a screwdriver or remover, remove the roof molding (A).
Installation is the reverse of removal.
Put on gloves to protect your hands.
Replace any damage clips.
