1.
Installation is reverse of removal.
note
After removing or replacing fuel system below, must perform fuel leakage test procedure. (Refer to "Fuel leak test" in this group.)
-
Fuel tank
-
Fuel sender
-
Fuel filter
-
High pressure fuel pump
-
Injector
-
Common rail
-
Low pressure fuel line
note
When installing the injector, MUST REPLACE the O-ring (A) and apply a grease to that.
note
When installing the high pressure fuel pipe, apply the specified tightening torques with the special service tool (SST No.: 09314-27120).
Injector clamp installation bolt:
28.4 ~ 30.4 N.m (2.9 ~ 3.1 kgf.m, 21.0 ~ 22.4 lb-ft)
High pressure fuel pipe installation nut:
24.5 ~ 28.4 N.m (2.5 ~ 2.9 kgf.m, 18.1 ~ 20.1 lb-ft)
