1.
Remove the room lamp assembly then check for continuity between terminals.
Remove the front map lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.
Remove the room lamp assembly then check for continuity between terminals.
Disconnect the negative (-) battery terminal.
Remove the mounting screws (2EA).
And then remove the front map lamp (A).
Remove the front map lamp (B) from the head lining after disconnecting the panoramaroof switch connector and map lamp switch connector (A).
If the bulb only should be replaced, replace the bulb after removing the lens.
Disconnect the negative (-) battery terminal.
Remove the front map lamp lens (A).
Remove the mounting screws (2EA).
Remove the room lamp (B) from the head lining after disconnecting the front map lamp switch connector (A).
Remove the room lamp bulbs (2EA).
Install the front map lamp after connecting the panoramaroof switch connector and lamp connector.
Install the lens after tightening 2 screws.
Install the front map lamp assembly after connecting the lamp connector.
Install the lamp lens after tightening 2 screws.
