3.
Has a problem been found ?
 | ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Power Circuit Inspection" procedure. |
Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check all connectors(and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Has a problem been found ?
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to "Power Circuit Inspection" procedure. |
Ignition "OFF".
Disconnect Brake Lamp Switch connector.
Ignition "ON".
Measure voltage between Pin No. 3 (Power) terminal of brake lamp switch harness connector and chassis ground.(LHD)
Measure voltage between Pin No. 2 (Power) terminal of brake lamp switch harness connector and chassis ground.(RHD)
Specification : B+
Is the measured value within specifications ?
| ▶ Go to "Signal Circuit Inspection" procedure. |
| ▶ Repair open or short in power circuit of Brake Switch harness connector and then go to "Verification of vehicle Repair" procedure. |
Ignition "OFF"
Disconnect Battery (-) terminal.
Disconnect Brake lamp switch connector.
Measure resistance between Pin No. 4 (Signal) terminal of brake lamp switch harness connector and Pin No. 30(Signal) terminal of HECU.(LHD)
Measure resistance between Pin No. 1 (Signal) terminal of brake lamp switch harness connector and Pin No. 30(Signal) terminal of HECU.(RHD)
Specification : Approx. below 1 Ω
Is measured value within specification?
| ▶ Go to "Component Inspection" procedure. |
| ▶ Repair open or short in ground circuit of Brake Switch harness connector and then go to "Verification of vehicle Repair" procedure. |
