8.
Perform the procedure in accordance with the message.
Turn ignition switch OFF.
Disconnect the electric EGR control valve connector.
Measure resistance between terminal 1 and 2 of the valve.
Check that the resistance is within the specification.
Specification: Refer to Specification section.
After replacing the Electric EGR valve, MUST perform the "ECU Initialization" procedure.
Otherwise trouble related with engine performance or emission control may occur until ECM learning about the component is over.
Turn ignition switch OFF.
Connect a GDS to Data Link Connector (DLC).
Turn ignition switch ON.
Select "Vehicle, Model year, Engine, System".
Select "Vehicle S/W Management".
Select "ECU Initialization".
Select "E-EGR valve Change".
Perform the procedure in accordance with the message.
