13615519

1.

Disconnect the lamda sensor connector (A).

2.

Remove the front muffler (A).

Tightening torque :

39.2 ~ 58.9N.m (4.0 ~ 6.0kgf.m, 28.9 ~ 43.4lb-ft)

3.

Remove the particulate matter (PM) sensor from the center muffler.

(Refer to Engine Control / Fuel System - "Particulate Matter (PM) Sensor")

4.

Remove the center muffler (A).

Tightening torque :

Nuts (B) : 39.2 ~ 58.9N.m (4.0 ~ 6.0kgf.m, 28.9 ~ 43.4lb-ft)

Clamp (C) : 16.7 ~ 26.5N.m (1.7 ~ 2.7kgf.m, 12.3 ~ 19.5lb-ft)

When installing the clamp in between the center pipe and main muffler pipe ;

(1)

Align the marks on the center pipe and main muffler pipe as shown illustration.

(2)

The clamp installing position (A) must be upper than the line virtually made by the two marks.

caution

Do not reuse the clamp.

5.

Remove the main muffler (A).

6.

Installation is the reverse order of removal with new gasket.