4.
Measure resistance between voltage supply terminal and ground terminal of APS2.
Turn ignition switch OFF.
Disconnect the accelerator position sensor connector.
Measure resistance between voltage supply terminal and ground terminal of APS1.
Measure resistance between voltage supply terminal and ground terminal of APS2.
Check that the resistance is within the specification.
Test Condition | Output Voltage (V) [Vref=5V] | |
APS 1 | APS 2 | |
Idle | 0.7 ~ 0.8 | 0.275 ~ 0.475 |
Fully depressed | 3.8 ~ 4.4 | 1.75 ~ 2.35 |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the accelerator pedal position sensor connector (A).
Remove the accelerator pedal assembly from the vehicle after unscrewing the mounting nut (B).
[LHD]
[RHD]
Installation is reverse of removal.
Fuel pump installation nuts:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
