2.
Disconnect the vehicle speed sensor connector (B) and the back lamp switch connector (A).
Remove the following items;
Engine cover
Air cleaner assembly and air duct.
(Refer to "Intake and Exhaust system" in EM group)
Battery and battery tray.
(Refer to "Charging system" in EE group)
ECM.
(Refer to "Engine Control System" in FL group)
Disconnect the vehicle speed sensor connector (B) and the back lamp switch connector (A).
Remove the ground wire by removing a bolt.
Remove the snap pins (A) and clips (B).
Remove the control cable bracket by removing bolts(3ea).
After removing the clip (A) and take off the clutch tube, remove the bracket mounting bolt (B).
Remove the cowl top cover or wiper motor.
(Refer to "Windshield Wiper/Washer" in BE group.)
Remove the cowl complete assembly panel (A).
Remove the head lamp.
(Refer to "Lighting System" in BE group.)
Using the engine support fixture [Support (SST No.: 09200-1P200), Adaptor (SST No.: 09200-1P100), Beam (SST No.: 09200-38001/3N000)] hold the engine and transaxle assembly safely.
Remove the transaxle upper mounting bolts (A-2ea) and the starter motor mounting bolts (B-2ea).
Remove the transaxle support bracket bolts (A-3ea).
Lifting up the vehicle.
Remove the under cover (A).
Drain the transalxe fluid by removing the drain plug (A).
Disconnect the drive shafts from the transaxle. (Refer to "Front Driveshaft" in DS group)
Remove the CKP sensor (A) by removing a bolt.
Remove the roll stopper bracket by removing bolts (A-1ea,B-2ea).
Remove the clutch release cylinder assembly (A) by removing bolts (B-2ea).
Remove the bolt left in the engine side.
Supporting the transaxle with a jack, remove the transaxle lower mounting bolts (A-3ea, B-2ea).
Lowering the jack slowly, remove the transaxle.
If the oil seal on the transaxle case side is damaged and fluid is leaking, replace the oil seal with a new unit.
When installing the new oil seal, use the specialized tool (oil seal installer, 09452-21200).
Adding Manual transaxle fluid.
(Refer to "Manual transaxle system" in this group.)
Installation is the reverse of removal.
