1.
Remove the door scuff trim (A).
[Front]
[Rear]
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Remove the door scuff trim (A).
[Front]
[Rear]
Installation is the reverse of removal.
Replace any damage clips.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Remove the front pillar trim (A).
Disconnect the speaker connector (A).
Installation is the reverse of removal.
Replace any damage clips.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Remove the front door scuff trim.
Remove the hood release handle.
(Refer to the BD group – “Hood”)
Remove the cowl side trim (A).
Installation is the reverse of removal.
Replace any damage clips.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Remove the front and rear door scuff trim.
Remove the front seat belt lower cover (A).
After loosening the mounting bolt, then remove the front seat belt lower anchor (B).
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Remove the center pillar lower trim (A).
Disconnect the cap, loosening the mounting bolts.
Remove the center pillar upper trim (A).
Installation is the reverse of removal.
Replace any damage clips.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Remove the rear seat.
(Refer to BD group – “Rear Seat”)
Remove the rear door scuff trim.
Detach the mounting clips, remove the transverse trim (A).
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb.ft)
Remove the lamp (A), disconnect the connector (B).
After loosening the mounting screws, then remove the luggage side trim (C).
After loosening the mounting screws, then remove the rear pillar trim (A).
If the clips (B) of rear pillar trim (A) are hot installed correctly, the curtain airbag abnormal operation might be occured.
Installation is the reverse of removal.
Replace any damage clips.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.
Remove the rear seat.
(Refer to BD group – “Rear Seat”)
Remove the transverse trim.
After loosening the mounting screws, then remove the luggage side trim.
Installation is the reverse of removal.
Replace any damage clips.
1. Luggage side trim (RH) 2. Luggage side trim (LH) 3. Transverse trim | 4. Center shelf trim 5. Luggage board trim 6. Luggage floor net |
